I saved this chart. Thanks again!

 

Thanks! Are the pins numbered? Is there a diagram for that?

 

You are welcome. No photos as of yet, I will update as they are available.
This info can change depending on if you do have the Intelligent key (I believe most do). Before using the above info and blaming me for anything, this is tech info available to me from Directed Electronics, if you have something you are unsure of, PM me and I will check for any updates/notes.




See attached doc in first post.

 

Great info

 

Is this for a car with or without nav?

 

Either, there are specific notes on some wiring (ex intelligent key 12 volt wire vs non intelligent 12 volt wire) but nothing different so far with nav. Did you have a particular concern I can hunt down an answer for?

 

so if i cut the yello speed sence wire to the radio i would be able to type in my gps address while on the move?

 

Satellite would know you are moving. At least that is how it works on most. There are ways around that "safeguard" too.
Do a search on the forum, I seem to recall someone already completing a bypass.

 

so there is a difference between inteligent key and non.......
I got another scematic that states the sub is on 30 and 31 pin and a shield on pin 32.

 

There are no notes indicating any difference in the sub wiring. That being said, for the Nissan Cubes there are variations in wire codes depending on US/International models. So far the Juke only shows up on the US charts. Not saying this is true for the Juke as well....Just offering hope.

 

Well, I just discovered that my rear speaker are completely different from the chart??
Left is lt green and brown and right is brown and grey.
CRAP! Gonna have to do the 9v battery test on the old speakers to determine polarity.

 

OK, the rears on my Juke are as follows...
Teal, or Light Blue or BLuish Green = Positive.

I did a test on the old speakers and the teal side was definitely positive.

Yes, both rears are the same color.
Sorry for the mis-info above. But it is still different from the chart a bit.

I was working from memory. (bad memory apparently)

 

So it seems the negative wires are different, as the colors you mention above and on your previous post still line up (left = Light Green. right = brown) with the chart for positive. I will submit feedback, thank you.

 

Does someone have a picture of the subwoofer pinplug with the cable colours?
Because in the european cars there's a pinplug but it seams that the pinplug is different then the us models... hoping on plug and play here......
thanks.

 

Plug and play in what manner? As in you don't have the Rockford subwoofer/amp combo, but want to add one? If so, your vehicle is not pre wired.

 

2 thumbs up for photobucket for ipad

 

Are you buying the Rockford amp/sub combo and required panel? That is the main question I had. If not, none of that wiring truly matters.

 

I'm thinking of that yeah.... All OEM... so the RF amp/sub and maybe the panel too... First I'll try to fit the sub somewhere else... Perhaps under the drivers seat... or under the dash..

 

Thanks!

 

You are welcome.

 

Can enyone help me to find the microfone pins in bosch satnav unit from 2011 juke and wiring layout on stereo plug
Thanks

 

does the non nav package juke still have the wiring for the woofer back there so i could run my own woofer or does the factory head unit have rca outs?

 

No RCA outputs


Sent from my Autoguide iPad app

 

These are the wiring colors in my 2011 LS AWD

 

Does the none Bluetooth Radio radio still have the mic installed in the loom ?

 

Do the plugs on the wiring loom of the SV radio/cd/phone unit fit the OEM nav/radio/phone unit of the SL? I realize there needs to be a sat. ant. but other than that is it plug and play?

thanks

 

How are the factory tweeters wired? Is there a cross over? Are the wires at the door speakers carrying full range or low pass?

Sent from AutoGuide.com Free App

 

How are the factory tweeters wired? Is there a cross over? Are the wires at the door speakers carrying full range or low pass?

Sent from AutoGuide.com Free App

I'd like to know that too! My driver's side tweeter isn't making any sound, and I would rather check the connections myself before going through the hassle of warranty work.

 

Hi
Please see my post "Steering wheel controls " you might be my best hope. Thanks in advance for your help.

 

Hi all,
Having major wiring conflict with a Android 4.4 head unit I’m trying to install in my 2014 Juke ST.
The wiring seems to be very different to anything else I have seen so far on this forum. I have also looked extensively online for an adaptor to suit the ISO connector on the new head unit but to no avail. There are 2 connectors;
White, 20 pin connector;
Brown, Brown (lighter), Green, Green (lighter), Red, Pink, Yellow x2, Purple x 2, White, White(with grey dot), Teal, Blue, Light Blue, Black.
White, 12 pin connector;
Black x 3, Red, Green.
Anyone out there with a better idea of what goes where? Still yet to investigate how I am going to go about connecting the steering wheel controls as I’m sure they have changed now too.