Nissan Juke : Juke Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi All, I am trying to remove what is left of this pulley from the alternator shaft of my 2014 Juke SLawd. My issue is that the dimple in the center of the shaft appears round so no torx, hex etc bit fits to hold this while the spline socket turns off the remaining pulley core. Any ideas or type of bit that should fit would be so appreciated. Thanks in advance.
 

·
Administrator
Joined
·
11,782 Posts
Isnt it for the pulley puller ?
 
1 - 4 of 4 Posts
Top