Nissan Juke : Juke Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hey all I'm new here and have a 2012 Juke SV. My passenger side window won't go up via the switch but will go down. Drivers side switch works both ways. Is there a way to access the switch to replace it without taking the door panel off?
If not, could someone with limited knowledge of removing door panels do so relatively easily?

Thanks and hopefully I've posted this in the appropriate section.
 

·
Super Moderator
Joined
·
1,769 Posts
Welcome to the forums. I believe the door trim pieces that hold the switches just pop up with some force. they are held on with pawls that are basically clips holding it into the door finish. You may want to remove the handle pull first which is a screw in the bottom and 4 pawls around the sides. Get a good stiff plastic trim removal piece so you don't break or scratch something. Worst case you could wrap some electrical tape around a flathead screwdriver too.

EDIT: the FSM states you should pry up from the back and work your way towards the front.
 

·
Super Moderator
Joined
·
1,769 Posts
188402
 
1 - 4 of 4 Posts
Top